CO2 water jacketed incubator for microbiology, oncology, toxicology or pharmacology.

Technical features:

-Working temperature from +5°C above ambient to +55°C.

-Outer case in stainless epoxy painted steel plate with acid and rust-proof groud

-Inner chamber in stainless steel (AISI 304).

-Stainless steel water jacket, capacity 50 litres (distilled water)

-Inner glass door.

-Double-wall heated front door (anti-condensation), outside enamelled steel,

inside stainless steel.

-Heating through stainless steel sheated resistor of 1000 W.

-CO2 range up to maximum 20%

-CO2 regulation through electronic injection system.

-Quick CO2 recovery device for door open.

-Digital thermostat with microprocessor allowing P.I.D. auto-tuning to control CO2%

and temperature.

-Safety thermostat with alarm light for over-temperature and set CO2 fluctuation.

-Stainless steel water tray in inner chamber to provide humidity.

-CO2 inlet connector.

-CO2 sample connector.

-Pressure rilief valve.

-Visible liquid level monitor for water jacket with drain tap.

-Mains switch, mains lead with safety fuses.

-Pressure connector and plastic pipe for CO2 included.

-2 holed stainless steel trays plus 1 water tray (humidity) included

-220 V. – 50 Hz. Single Phase.

-Opional extra shelves and epoxy painted steel trolley available.

Internal dimensions (W x D x H) cm. 62 x 55 x 60 - Capacity: 204 litres

External dimensions (W x D x H) cm. 100 x 75 x 85 -

Shipping dimensions (W x D x H) cm. 115 x 90 x 110

Net weight: kg. 140

Shipping weight: kg. 200